Availability:
Estimated Arrival: Between
Jun 20
and
Jun 30.
*ETA to USA Only
Fast Free Shipping. Free Shipping to lower 48 States.
See our a Shipping and Returns Policy.
Guaranteed Lowest Price. We price match our competitors, so you're sure to get the lowest price here.
Have a Question? Give us a call at 509-730-5520 or send us an e-mail at info@ToiletOasis.com.
-
- This is a complete Saniaccess 3 system and includes a toilet (Saniflo elongated toilet bowl (Item #087) or Saniflo round toilet bowl (Item #83), Saniflo soft-close toilet seat, Saniflo toilet tank (Item #005) and the Saniflo macerating pump unit (Item #082). An optional extension pipe (Item #030) is available for the pump to be installed behind the wall. The extension pipe can be purchased here: Saniflo Extension Pipe. The system does not include any vanities, shower, or bathtub which may be shown for illustration purposes.
- The Saniaccess 3 is a 1/2 HP pump system used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away from a soil stack. It incorporates a macerating system which can handle human waste and toilet paper in residential applications. The blade is made out of a hardened stainless-steel material which eliminates the need for any service or replacement.
-
The inside of the Saniaccess 3 macerator pump comprises of a pressure chamber, which starts and stops the unit, and the motor, which drives the stainless steel macerator blades and the pump. When the flush is activated, the water flowing into the Saniaccess 3 activates a micro switch in the pressure chamber, which in turn starts the motor. The motor is sealed for life in an oil filled enclosure. A common spindle/shaft drives the impeller and the macerator blades. The moving parts therefore are kept to an absolute minimum. Water and organic waste matter enter the chamber and are reduced to slurry as the macerator blades rotate at 3600 RPM. The centrifugal force causes the reduced solids to be ejected through a grill into the container where it is picked up by the impeller pump mounted beneath the motor. The unit pumps the effluent upward to 15 feet and/or 150 feet horizontally (with gravity fall). Once the water level in the container goes down, the micro switch deactivates the unit until the flush is activated again. A normal operating cycle for Saniaccess 3 takes about 10 - 12 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal. -
In addition to the toilet waste, the Saniaccess 3 will also discharge gray water from a variety of other sanitary fixtures such as: a sink, a bathtub, a shower and a urinal. When adding a bathtub or shower, a base will have to be constructed. This base should be made out of a 2" x 6" (minimum) or 2” x 8” (recommended) on edge, to allow for the installation of a P-trap and the required 1/4”per foot gravity flow towards the pump unit.
The wastewater from other sanitary fixtures is discharged into the Saniaccess3 via two 2-inch inlets on either side of the housing. Either one or both inlets can be used as required. The discharge elbow on top of the Saniaccess3 can be turned either to the left, to the right, or towards the back, depending on the discharge installation. A non-return valve, which comes already assembled on the discharge elbow, prevents back flow into the unit.
This unit has been designed with a vent connection on the lid. All plumbing codes require connection to a vent system. Please note that the vent system should be a two-way air vent. The use of mechanical vents, air admittance valves or similar devices are not permitted as these are considered one-way air vent systems. It is also highly recommended for the macerator/pump to be connected to a Ground Fault Interrupter (GFI) circuit.
The design of this model consists of vibration absorbers which enable the reduction of operating sound by reducing the transmitted sounds from any location where such resonance transmission could occur. This new design reduces the operating sound of this pump by 10dB.
The Saniaccess3 unit must be connected to our rear discharge toilet. This system uses much less water than a regular toilet. Note: This toilet only works in combination with Saniflo systems.
The Saniaccess3 has been certified to American and Canadian Standards. Macerating standard; US: CSA Certified & IAPMO (UPC) listed - ASME A112.3.4, CA: Macerating Standard CSA B45.9. -
Benefits and Features: - ✔Allows you to build a bathroom in a basement or other area where the connecting sewer gravity pipe is higher than your bathroom. Also allows you to have a bathroom in a closet or other area where sewer is not currently plumbed in.
- ✔Saniaccess3 macerator is sized for a full bathroom. It can handle wastewater from the toilet, shower, bathtub, and sink.
- ✔Discharges the waste through a 3 ⁄ 4 ” or 1” rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system. This elbow can be rotated 360 degrees depending on the discharge installation.
- ✔The round bowl toilet, with soft close seat, is ADA compliant.
- ✔2-year Full Manufacturer Warranty. Extended 3-year Warranty with product Registration (www.Saniflo.com/Register).
-
- See Saniflo Saniaccess 3 Macerating Pump manual here.
TECHNICAL SPECIFICATIONS Pump type: Macerator Electrical: 120 V – 60 Hz / 4.5 Amps (Max) Motor: 0.5 HP oil-filled thermally protected motor Capacitor rating: 45 microfarad Operating Temperature: 104°F (110°F Max.) Power cord length: 51 inches Noise level: ≤ 53 dBA (Lp) (measured at 3 ft.) Discharge pipe diameter: 3⁄4” or 1” Discharge Rate at 15 ft: 17 GPM Discharge Rate at 3 ft: 27 GPM Shut-off head: 30 ft. Normal running time: 10-12s Capacity: 3.1 gallons / 11.4 liters Inlets: 2” (sides), 1–1⁄2” vent (top) Method of activation: Membrane/microswitch Shower/bathtub base height: 6” min Weight: 18 lbs / 8.2 kg Certifying agencies: CSA (IPC, NSPC), IAPMO (UPC) Recommended accessories: Descaler, Sanialarm Connections: Rear outlet toilet, sink, shower/bathtub
-
-
No questions at this time.
-
-
- Thank you for considering purchasing with ToiletOasis.com. Give us a try and you won't be disappointed!
All of our products are shipped from within the U.S.A. from one of our warehouses which our scattered throughout the country.
We typically use FedEx to ship, but may use a different carrier depending on your location. Shipments are typically made within 3 to 5 days and will typically arrive within 1 to 5 days after leaving the warehouse.
To see our full Shipping & Returns Policy please visit our page here.
Order Confirmation:
As soon as you place your order with us, you will receive an order confirmation to the e-mail that you provide us. This means that we have received your order in our system and pre-authorized your credit card for the purchase. As soon as we receive your order, we automatically reach out to our warehouse to confirm that it is in stock and available for immediate shipment. If your item is on backorder or unavailable, we will void the pre-authorization and reach out to you via e-mail. If your item(s) are available for immediate shipment (within 5 business days), we will process the charge and submit the order for shipment.
If you have any questions, please contact us.
- Thank you for considering purchasing with ToiletOasis.com. Give us a try and you won't be disappointed!